SKF bearing because when fatigue damage or improper operation, in particular those bearing on the cover, shell, if you do not have appropriate uninstall tool is very difficult to get it out.
So, how do we remove it? At this time, you can take the generator end cap upside down on top of the table, pad of soft wood or cloth, and add some butter in its bottom bearing, and then cutting some scrap cloth into SKF bearings and between the bottom cover. Initially in cloth is as small as possible, wait for the clearance of the SKF bearings and end cap when relatively large, can continue to increase and more cloth. First to has cut good of cloth block placed in joined of butter on, then again found a root diameter and bearing of diameter difference not is large of and end comparison flat of round or screws, next on with hammer and round to percussion cloth block, while continued to joined new of butter and cloth block, such bearing and cover Zhijian of gap also on will increasingly large, so until can removed bearing weizhi.