1, the use of angular contact ball bearings, regular cleaning is a very primary. What exact cleaning bearings? When the first bearing removed soujian, first appearance, including photographic records. In addition, sampling to confirm the amount of remaining lubricants and lubricants and cleaning FAG bearings.
2, bearing wash wash the cleaning of rough and refined suspension, and can use the metal rack on the bottom of the container.
3, rough when washing, oil enough brush to eliminate grease or adhesive material. If migration change bearings in oil, blending note due to foreign object damage roll.
4, essential when washing, oil slowly migrating into bearings, must work harder to stop.
5, cleaning agent for weekday use neutral non water-diesel oil or oil temperature upon request, sometimes using lye. No matter what kind of cleaning agent, has to clean the filter often confrontation.
6, after cleaning, immediately on the coating rust preventive oil or rust on the angular contact ball bearing grease.
Wanted for mechanical operation of the angular contact ball bearings for longer service, diagonal contact ball bearings on a regular basis do routine testing is necessary, can be effectively detected through testing machine operation problems associated with, get a good solution to the problem, effectively increases the life span of FAG bearings.
Primary observation on the bearing rivets in the detection head welding position did skew, relaxation is not the right. Retainer weld is good or bad. Weld is too small, welding is not secure, or welding ball problems caused by excessive. Are detection of angular contact ball bearings where particular attention is needed in the process. There are also some issues that need attention.
The detection of bearing partial. Angular contact ball bearing on the environment first check should be conducted in a light environment, preferably astigmatism, so as to better external observation to the bearing, its surface without cracks and other strange. Such as mechanical wear during cloud, scratch, touching will result in bearing offsets, leading to adverse device location, causing flat load and stress concentration, modeling of FAG bearings precision and reduced service life.
Working environment also pays special attention to the moisture or contaminants, those most likely to cause the bearings rusted, rusty is causing poor angular contact ball bearings installed, early wear, more serious result in bearing directly scrapped. So special attention during use waterproof.